Table of Contents
Advertisement
Unpacking
The package contains the following items. Contact the shipper or your Audiocom dealer immediately if anything is damaged
or missing. Detach and fill out the registration card and return it to Telex to properly register your US2002.
Quantity
1
1
1
4
1
Configuration Pre-check
Before connecting the US2002 make sure it is properly configured for your intended usage. Figure 2 on page 8 shows the
locations of the configuration jumpers and switches. To access internal switches and jumpers, remove one screw from the top
cover and three screws from each side. Note, switch SW2 can be accessed through the back panel.
NOTE: If you change any switch settings while the US2002 is operating, you must perform a reset: either cycle power OFF
then ON, or simultaneously press the All Talk and Listen 1 keys, then release them. The sidetone controls are adjusted after
power-up and are normally accessed through the bottom cover.
Description
US2002 Intercom Station
Warranty and Registration Card
User Manual
Rubber feet for desktop use of the US2002
Termination plug for special applications (Figure 13 on
page 22)
CHAPTER 2
Installation
7
Advertisement
Table of Contents
