Changing The Presser Foot; Replacing The Presser Foot; Attaching The Presser Foot With The Included Adapter - Baby Lock Altair 2 Instruction & Reference Manual

CHANGING THE PRESSER FOOT

CAUTION
• Always touch
keys and buttons before changing the presser
foot. If is not touched and the "Start/
Stop" button or another button is pressed, the
machine will start and may cause injury.
• Always use the correct presser foot for the
selected stitch pattern. If the wrong presser
foot is used, the needle may strike the presser
foot and break, and may cause injury.
• Make sure that the presser foot is installed in
the correct direction, otherwise the needle
may strike the presser foot, breaking the
needle and causing injuries.
IMPORTANT
• Use presser feet made for this machine.

Replacing the Presser Foot

a
Press (Needle position button) to raise the needle.
b
Touch to lock all keys and buttons.
* If the message [OK to automatically lower the
presser foot?] appears on the LCD screen, touch
to continue.
c
Raise the presser foot lever.
d
Press the black button on the presser foot holder and
remove the presser foot.
a
e
Place the new presser foot under the holder, aligning
the foot pin with the notch in the holder. Lower the
presser foot lever so that the presser foot pin snaps into
the notch in the holder.
a
on the screen to lock all
1 Black button
2 Presser foot holder
1 Notch
2 Pin
CHANGING THE PRESSER FOOT
f
Raise the presser foot lever to check that the presser
foot is securely attached.
g
Touch to unlock all keys and buttons.
Attaching the Presser Foot with the Included
Adapter
Some presser feet require using the included adapter and
small screw, for example, the free motion echo quilting foot
"E" and so on.
 Attaching the Walking Foot (Sold Separately)
The walking foot holds the fabric between the presser foot
and the feed dogs to feed the fabric. This enables you to
have better fabric control when sewing difficult fabrics
(such as quilted fabrics or velvet) or fabrics that slip easily
(such as vinyl, leather, or synthetic leather).
Note
• Thread the needle manually when using the
walking foot, or only attach the walking foot after
threading the needle using
threading button).
• When sewing with the walking foot, sew at medium
to low speeds.
Memo
• The walking foot can only be used with straight or
zigzag stitch patterns. Reverse stitches cannot be
sewn with the walking foot. Only select straight or
zigzag stitch patterns with reinforcement stitches.
(page 59)
a
Follow the steps in "Replacing the Presser Foot" on
page 49.
b
Loosen the screw of the presser foot holder to remove
the presser foot holder.
b
(Automatic
1 Presser foot holder
screw
2 Presser foot holder
1
49