Table of Contents
Advertisement
SSF - Elevation: A linear multiplier that accounts for vertical scaling. Not all rifle scopes track perfectly, so the
ballistics solution requires a correction to scale according to a particular rifle scope. For example, if a turret is
moved 10 mil but the impact is 9 mil, the sight scale is 0.9. Input field.
SSF - Windage: A linear multiplier that accounts for horizontal scaling. Not all rifle scopes track perfectly, so the
ballistics solution requires a correction to scale according to a particular rifle scope. For example, if a turret is
moved 10 mil but the impact is 9 mil, the sight scale is 0.9. Input field.
Twist Rate: The distance it takes for the rifling of your barrel to make one full rotation. Rifle twist is often
provided by the gun or barrel manufacturer. Input field.
Zero Height: An optional modification to impact elevation at zero range. This is often used when adding a
suppressor or using a subsonic load. For example, if you add a suppressor and your bullet impacts the target
1 inch higher than expected, your Zero Height is 1 inch. You must set this to zero when you remove the
suppressor. Input field.
Zero Offset: An optional modification to impact windage at zero range. This is often used when adding a
suppressor or using a subsonic load. For example, if you add a suppressor and your bullet impacts the target
1 inch to the left of the expected impact, your Zero Offset is -1 inch. You must set this to zero when you
remove the suppressor. Input field.
Zero Range: The range at which the rifle was zeroed. Input field.
Profile Fields, Gun Properties, Calibrate Muzzle Velocity
Range: The distance from the muzzle to the target. Input field.
TIP: You should enter a value as close as possible to the range suggested in the shooting solution. This is the
range where the bullet slows to Mach 1.2 and begins to enter the transonic range.
True Drop: The actual distance the bullet falls while in flight to the target, displayed in milliradians (mil) or
minute of angle (MOA). Input field.
Profile Fields, Gun Properties, Calibrate Drop Scale Factor
Range: The range from which you are shooting. Input field.
TIP: This range should be within 90% of the recommended range suggested in the shooting solution. Values
that are less than 80% of the recommended range will not provide a valid adjustment.
True Drop: The actual distance the bullet falls when fired at a specific range, displayed in milliradians (mil) or
minute of angle (MOA). Input field.
Unified Training Status
When you use more than one Garmin device with your Garmin Connect account, you can choose which device is
the primary data source for everyday use and for training purposes.
From the Garmin Connect app, select
Primary Training Device: Sets the priority data source for training metrics like your training status and load
focus.
Primary Wearable: Sets the priority data source for daily health metrics like steps and sleep. This should be the
watch you wear most often.
TIP: For the most accurate results, Garmin recommends that you sync often with your Garmin Connect account.
74
Training
> Settings.
Training
Advertisement
Table of Contents
