Audio Visual Configuration - CYBEX 625T Service Manual

Audio Visual Configuration

Audio Visual is available in three configurations: Shared TV's, Personal TV on a stand, or TV embedded
in product.
Perform the following procedures to complete the audio visual setup.
• Assemble product.
• Determine audio visual configuration.
• Configure product for one of the three configurations.
• Install and setup audio visual components.
Determine Audio Visual Configuration
Determine which audio visual configuration you have.
Shared TV setup
Shared TV's on wall or hanging
from ceiling. Audio is sent to
product via wireless transmitter.
See Shared TV Setup
A/V setup mode
1. Plug the power cord into a power outlet from a grounded, dedicated circuit as described under
Electrical Requirements in this chapter.
Do not stand on treadmill during this procedure.
2. Ensure the power cord is not being pinched under the front of the treadmill.
3. Toggle the power switch on (|).
Power switch is located under the front end of the treadmill. The control panel will lightup and be in
the Dormant Mode.
Cybex 625T Treadmill Part Number
Personal TV setup
Personal TV on a stand. TV is
controlled with a C.A.B. (Console
Adapter Box) or C-tv (Connected
TV) connect to the product.
See Personal TV Setup
Falling hazard. When starting unit
• Stand on two top steps.
• Do not stand on belt.
Page 31 of 209
Embedded TV setup
TV embedded in product. The
product uses the E3 View Monitor.
See Embedded TV Setup