Siemens SIMATIC S7-1500 System Manual page 88

System overview
5.3 SIMATIC Drive Controller functions
Motion Control technology functions
The following table shows the technology functions supported by SIMATIC Drive Controller .
Table 5- 5
SIMATIC Drive Controller technology functions
Enable, disable technology objects
Acknowledge alarms, restart technology object
Reference technology objects, set reference point
Halt axis
Position axis absolutely
Position axis relatively
Move axis at set velocity/speed
Move axis in jog mode
Position axis overlapping
Set alternative encoder as operationally active encoder
Pause superimposed motions on the axis
Halt and disable axis
Enable/disable hardware limit switch
Control bits of control word 1 and 2
Save absolute encoder adjustment for device replacement
Start one-time measuring
Start cyclic measuring
Abort active measuring
Enable/disable output cam
Enable/disable cam track
Start gearing
Start gearing with specified synchronous positions
Start velocity synchronous operation
Absolute shift of master value on the following axis
Relative shift of master value on the following axis
Absolute shift of following value on the following axis
Relative shift of following value on the following axis
Start camming
Simulate synchronous operation
Desynchronize gearing
Desynchronize camming
Specify additive master value
Interpolate cam
Read out slave value of a cam
Read master value of a cam
Copy calculated cam elements
Specify motion setpoints
Specify superimposed motion setpoints
Enable and disable force/torque limit / fixed stop detection
Specify additive torque
Specify upper and lower torque limits
86
Motion Control technology functions
SIMATIC Drive Controller
System Manual, 11/2023, A5E46600094-AD