Configuration Switches; Dip Switches; Dip Switch 1; Dip Switch 2 - RTS BKP-4 User Manual

CONFIGURATION SWITCHES

If you change any configuration switch settings during operation, you must momentarily turn off
Important!
power to reset.

DIP Switches

DIP Switch 1

Open: Default setting. All incoming calls appear in the call waiting display (if present).
Closed: Only calls for unassigned callers appear in the call waiting display (if present).
Description: Any intercom key that is already assigned to talk/listen to a specific intercom port
will always provide an LED flash for incoming calls from that port. If a designation strip is used
the keypanel operator can identify the caller from the designation strip. Optionally, the caller's
name can also display in the call waiting window. If you don't want this to happen, set DIP switch
1 to Close.
The above description applies only to assigned keys. Whenever there is an incoming call, and
NOTE
there is no key assigned to the caller, that caller's name will always display in the call waiting
window.

DIP Switch 2

Open: Default setting. 15 second flash after incoming call is received.
Closed: LED flash until caller releases key.
Description: Whenever there is an incoming call and there is a talk key assigned to the caller, the
talk LED next to that key will flash. The flash can be set for 15 second timeout, or until the
caller's talk key is released.

DIP Switch 3

Open: Default setting. Cannot answer incoming calls to TIF-951 or TIF-2000.
Closed: TIF operation enabled.
Description: The unit can answer incoming telephone calls received by an RTS model TIF-951 or
TIF-2000 telephone interface. However, it cannot perform any other telephone operations. For
example: It cannot force the TIF to hang-up at the end of a call. In many cases, the TIF units can
detect a hang-up at the far end of the line and then hang-up itself. However, this may not always
be the case in all phone systems. In such cases you may leave TIF operation disabled.

DIP Switch 4

Open: Default setting. Use a panel mic (connected to the Mic connector) to talk and use the speaker
(connected to Speaker connector for MKP-4) to listen. Or, use a headset (connected to Headset connector)
to talk and listen.
Closed: Special Applications. Use a dynamic mic (connected to the Headset connector) with the
speaker (connected to Speaker connector for MKP-4). Or, use headphones (connected to the
Headset connector) with a panel mic (connected to the Mic connector).
Description: Typically, you will use the keypanel either with a panel microphone and a speaker or
with a headset. The special applications setting is seldom used.

DIP Switch 5

Open: Default setting. Latching turned on.
Closed: Latching turned off.
2-3