Refilling Coolant; Glass Fiber Yarn Filling Of Main Silencer; Removing Main Silencer; Installing The Main Silencer - KTM 250 XCF-W USA 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Refilling coolant

x
11.99
Warning
Danger of poisoning Coolants are poisonous and a health hazard.
–
Avoid contact between coolants and skin, eyes and clothing. If fuel gets into your eyes, rinse immediately with water and
contact a doctor. Wash affected skin areas immediately with soap and water. If coolant is swallowed, contact a doctor
immediately. Change clothes that have come into contact with coolants. Keep coolants out of the reach of children.

Glass fiber yarn filling of main silencer

11.100
The main silencer is filled with glass fiber yarn.
Over a period, the fibers of the insulating material vanish into the air, and the silencer "burns out".
Not only is the noise level higher, the performance characteristic changes.

Removing main silencer

11.101
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down. Do not touch hot components.

Installing the main silencer

11.102
–
Make sure that the screw
–
Stand the vehicle upright.
–
Pour coolant in up to measurement
Guideline
10 mm (0.39 in)
Coolant
600680-10
–
Refit the radiator cap.
–
Make a short test ride.
–
Check the coolant level. (
–
Disconnect spring
–
Remove screws
600681-11
–
Mount the main silencer. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Reconnect spring
600681-10
is tightened.

above the radiator fins.

1.2 l (1.3 qt.) Coolant (
Coolant (mixed ready to use)
(
p. 74)
.

and take off main silencer.

M6
.

p. 102)
p. 102)
.

10 Nm (7.4 lbf ft)
75