Using The Motion-Control Levers; Driving The Machine - Toro Z Master Professional 3000 Series Operator's Manual

Using the Motion-Control
Levers
Figure 25
1. Motion-control
lever—N -
EUTRAL LOCK
position
2. Center, unlocked position
3. Forward

Driving the Machine

The drive wheels turn independently, powered by
hydraulic motors on each axle. You can turn 1 side
in reverse while you turn the other forward, causing
the machine to spin rather than turn. This greatly
improves the machine maneuverability but may
require sometime for you to adapt to how it moves.
The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place
the throttle control in the F
performance. Always operate in the full throttle
position when mowing.
4. Backward
5. Front of machine
position for best
AST
CAUTION
Machine can spin very rapidly. Operator may
lose control of machine and cause personal
injury or damage to machine.
• Use caution when making turns.
• Slow the machine down before making
sharp turns.
g004532
23