Adjusting The Tracking; Checking The Tire Pressure - Toro Z Master Professional 3000 Series Operator's Manual

1. ROPS knob (locked
position)
2. Pull the ROPS knob out
and rotate it 90° to change
the roll bar position.

Adjusting the Tracking

1. Disengage the blade-control switch (PTO).
2. Drive to an open flat area, move the
motion-control levers to the N
position.
3. Move the throttle midway between fast and slow.
4. Move both motion-control levers all the way
forward until they both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. If it tracks to the right, loosen the bolts and adjust
the left stop plate backward on the left T-slot
until the machine tracks straight
7. If it tracks to the left, loosen the bolts and adjust
the right stop plate backward on the right T-slot
until the machine tracks straight
Figure 62
3. Roll bar in the upright
position
4. Roll bar in the folded
position
-
EUTRAL LOCK
(Figure
(Figure
8. Tighten the stop plate
1. Control lever
2. Bolt
g008943

Checking the Tire Pressure

Service Interval: Every 50 hours/Monthly (whichever
Maintain the air pressure in the rear tires at 90 kPa
(13 psi). Uneven tire pressure can cause uneven cut.
Check the tires when they are cold, to get the most
accurate pressure reading.
Note:
The front tires are semi-pneumatic tires and do
not require air pressure maintenance.
63).
63).
46
(Figure 63).
Figure 63
Left control lever shown
3. Stop plate
comes first)
g010153