Jeep GLADIATOR 2023 Owner's Manual page 101

5. Using the provided #T40 Torx head driver, remove
the four Torx head fasteners located along the
interior of the windshield (two on each side of the
header trim).
Step Five
1 — Outer Torx Fasteners
2 — Center Torx Fasteners
NOTE:
Store all of the mounting bolts in their original threaded
holes and tighten for safekeeping, or in the fastener bin
located below the rear seat.
6. Lower the windshield gently until it contacts the
tie-down bumpers (if equipped).
Step Six
1 — Washer Nozzle
2 — Bumper
3 — Tie-Down
7. Secure the windshield by passing a cinch strap
through the tie-down bumper on either side of the
hood and on the windshield frame. Tighten the strap
to secure the windshield in place.
CAUTION!
Do Not Overtighten! Damage to the windshield could result.
GETTING TO KNOW YOUR VEHICLE
Adaptive Cruise Control (ACC)/Forward
Collision Warning (FCW) Sensor Protective
Cover — If Equipped
Your vehicle may be equipped with a protective cover that
is to be used whenever the windshield is folded down in
order to protect the ACC/FCW sensor. To install the cover,
refer to the following instructions:
1. Secure the top part of the cover so that it hinges to
the header.
2. Swing the cover down and push on it so that it covers
the opening.
3. Check to make sure the cover is secured properly.
Protective Cover Installed
99
2