Jeep GLADIATOR 2023 Owner's Manual page 39

Screw Head Flush To Post
5. Close the door and repeat the "paper test".
Repeat the adjustment procedure if needed.
6. If needed, add the provided shim to a lower half-door
pocket to seal the upper half-door to the roof:
a. Lift upper half-door up and away from lower half.
b. Clean the bottom of the door pocket.
Remove Upper Half-Door & Clean Bottom Of Door Pocket
c. Slide the shim onto a pencil or similar tool.
d. Remove the paper backing from the adhesive side
of the shim and place the shim with pencil into the
pocket.
e. Press the shim firmly to the bottom of the pocket,
and remove the pencil once the shim is firmly in
place.
Press Shim Firmly Into Bottom Of Pocket
1 — Remove Paper Backing From Shim
2 — Slide Pencil through Hole In Shim
3 — Press Pencil With Shim Into Pocket
f. Replace upper half-door.
NOTE:
If the compression is increased too much on the front
upper corner of the rear doors, deformation of the seal will
occur.
GETTING TO KNOW YOUR VEHICLE
Half-Door Mirror Installation
To install the front door exterior mirrors on the half-doors,
proceed as follows:
1. Locate the wiring harness on the outside of the front
half-door.
Wiring Harness Location
2. Insert the wiring harness firmly into the connection on
the driver's side exterior mirror.
37
2