Chapter 6: Storage; Storage Safety; Preparing The Machine For Storage Over 30 Days - Toro Titan ZXM4875 Operator's Manual

Storage Safety

• Park the machine on a level surface, disengage the drives, engage the parking brake,
shut off the engine, remove the key, and wait for all moving parts to stop before leaving
the operator's position.
• Wait for the machine to cool before servicing, adjusting, fueling, cleaning, or storing it.
• Clean grass and debris from the cutting unit, muffler, drives, grass catcher, and engine
compartment to prevent fires.
• Clean up oil and fuel spills and remove fuel-soaked debris.
• Do not store the machine or fuel container where there is an open flame, spark, or pilot
light, such as on a water heater or other appliance.
Preparing the Machine for Storage Over 30
Days
1. Park the machine on a level surface, disengage the blade-control switch, and move the
motion-control levers outward to the P
2. Shut off the engine, remove the key, and wait for all moving parts to stop before leaving
the operating position.
3. Clean the machine.
You can wash the machine with a mild detergent and water. Do not pressure-wash the
machine. Avoid excessive use of water, especially near the drive system and engine.
Pressure-washing can force dirt and water into critical parts, such as spindle
bearings and electrical switches.
A. Remove grass clippings, dirt, and grime from the external parts of the entire
machine, especially the engine.
B. Scrape any heavy buildup of grass and dirt from the underside of the mower, then
wash the machine with a garden hose.
C. Run the machine with the PTO switch engaged and the engine at high idle for 2 to 5
minutes after washing.
4. Check the parking brake operation.
5. Grease the machine.
Storage
position.
ARK
IMPORTANT
Page 6–1
Chapter 6
Storage
3464-637 B