Table of Contents
Advertisement
5
Adjusting the Height of Cut
No Parts Required
Procedure
Note:
This cutting unit comes standard with the
Edgemax Micro-cut bedknife and standard bedbar.
The effective height of cut is dependent on previous
mower configurations and turf conditions (i.e., roller
type, bedknife behind center distance, soft or firm
greens, season conditions). Set initial height-of-cut to
0.25 mm to 0.38 mm (0.010 to 0.015 inch) higher than
previous setup and adjust to match conditions.
Note:
For heights of cut greater than 13 mm (0.500
inch), install the high height-of-cut kit.
Note:
Use the following chart to determine which
bedknife is best suited for the desired height of cut.
Recommended Bedknife/Height of Cut Chart
Bedknife
Part Number
Edgemax
115-1880 (2100)
Micro-cut
117-1530 (1800)
(Standard)
Edgemax
115-1881 (2100)
Tournament
117-1532 (1800)
(Optional)
Micro-cut
93-4262 (2100)
(Optional)
98-7261 (1800)
Tournament
93-4263 (2100)
(Optional)
98-7260 (1800)
Extended
108-4303 (2100)
Micro-cut
110-2300 (1800)
(Optional)
Extended
108-4302 (2100)
Tournament
(Optional)
Low-cut
93-4264 (2100)
(Optional)
110-2301 (1800)
1.
Loosen the locknuts securing the height-of-cut
arms to the cutting unit side plates
Height of Cut
1.5–4.7 mm
(0.062–0.188 inch)
3.1–12.7 mm
(0.125–0.500 inch)
1.5–4.7 mm
(0.062–0.188 inch)
3.1–12.7 mm
(0.125–0.500 inch)
1.5–4.7 mm
(0.062–0.188 inch)
3.1–12.7 mm
(0.125–0.500 inch)
4.7–25.4 mm
(0.188–1.00 inch)
(Figure
9).
1. Height-of-cut arm
2. Locknut
2.
Loosen the nut on the gauge bar and set the
adjusting screw to the desired height of cut
(Figure
10).
Note:
The distance between the bottom of the
screw head and the face of bar is the height of
cut.
1. Gauge bar
2. Height adjusting screw
3.
Hook the screw head onto the cutting edge of
the bedknife and rest the rear end of the bar
onto the rear of the roller
7
Figure 9
3. Adjusting screw
Figure 10
3. Nut
(Figure
11).
g014407
g000489
Advertisement
Table of Contents
