Table of Contents
Advertisement
Product Overview
Specifications
Tractors
Height-of-cut
Height-of-cut range
Reel bearings
Rollers
Bedknife
Bedknife adjustment
Grass shield
Counterweight
Net Weight, 2100 (without front roller)
Net Weight, 1800 (without front roller)
Attachments/Accessories
A selection of Toro approved attachments and accessories is available for use with the machine to enhance
and expand its capabilities. Contact your Authorized Service Dealer or Distributor or go to www.Toro.com for a
list of all approved attachments and accessories.
These cutting units mount on the appropriate size Flex and eFlex Traction Units.
The cutting height is adjusted on the front roller by 2 vertical screws and held by 2 locking
cap screws
Standard bench height of cut range is 1.6 mm (0.062 inch) to 12.7 mm (0.500 inch). The
bench height-of-cut range with the High Height of Cut Kit installed is 7 mm (0.285 inch) to 25
mm (1.00 inch). Effective HOC may vary depending on turf conditions, type of bedknife,
rollers and attachments installed.
There are 2 sealed stainless steel, deep groove ball bearings.
The front roller is 6.3 cm (2.5 inches) in diameter with a variety of configurations selected by
the customer. The rear roller is a 5.1 cm (2 inch) diameter aluminum full roller.
The replaceable single edged, high-carbon steel bedknife is fastened to a machined cast
iron bedbar with 13 screws (2100) or 11 screws (1800).
There is a dual screw adjustment to the reel; detents corresponding to 0.018 mm (0.0007
inch) bedknife movement for each indexed position.
The non-adjustable shield with adjustable cut-off bar improves grass discharge from the
reel in wet conditions.
A cast iron weight mounted opposite to the drive line balances the cutting unit.
11-Blade—32.2 kg (71 lb); 14-Blade—33.5 kg (74 lb)
11-Blade—30.8 kg (68 lb); 14-Blade—32.2 kg (71 lb)
11
Advertisement
Table of Contents
