Table Of Contents - Toro Greensmaster 04251 Owner's Manual

WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical
or chemicals known to the State of
California to cause cancer, birth defects,
or reproductive harm.
Introduction
Read this information carefully to learn how to operate
and maintain your product properly and to avoid
injury and product damage. You are responsible for
operating the product properly and safely.
You may contact Toro directly at www.Toro.com
for product safety and operation training materials,
accessory information, help finding a dealer, or to
register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready.
identifies the location of the model and serial numbers
on the product. Write the numbers in the space
provided.
1. Location of the model and serial numbers
Model No.
Serial No.
© 2017-The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Figure 1
Figure 1
This manual identifies potential hazards and has
safety messages identified by the safety-alert symbol
(Figure 2), which signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
1. Safety alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
Contents
Safety ....................................................................... 3
Safety and Instructional Decals .......................... 3
Setup ........................................................................ 4
1 Installing the Front Roller ................................. 4
2 Using the Cutting-Unit Prop.............................. 4
3 Adjusting the Bedknife to the Reel .................... 4
4 Adjusting the Rear Roller ................................. 6
5 Adjusting the Height of Cut............................... 7
6 Adjusting the Cut-off Bar .................................. 8
7 Preparing the Cutting Unit for Use on an
eFlex Machine ................................................ 9
Product Overview ....................................................11
Specifications ...................................................11
Attachments/Accessories ..................................11
Operation ................................................................ 12
Adjusting the Cutting Unit Daily......................... 12
Adjusting the Clip Setting.................................. 12
Maintenance ........................................................... 14
Servicing the Bedbar ........................................ 14
Backlapping the Reel........................................ 15
g016942
2
Figure 2
Contact us at www.Toro.com.
Printed in the USA
All Rights Reserved
g000502