Diskette Drives - HP ProLiant ML310 Generation 3 User Manual
Hide thumbs
Also See for ProLiant ML310 Generation 3:
- Setup and installation manual (170 pages) ,
- User manual (124 pages) ,
- Maintenance and service manual (90 pages)
Table of Contents
Advertisement
50
HP ProLiant ML310 Generation 3 Server User Guide
7. Install the retaining screw.
8. Connect the data and power cables to the back of the tape drive.
9. Connect the data cable into a SCSI controller channel ("System board
components" on page 11).
10. Remove the applicable bezel blanks from the bezel ("Front panel
components" on page 7).
11. Install the bezel ("Unlocking the bezel" on page 22).
12. Replace the access panel ("Removing the access panel" on page 22).
Diskette drives
A diskette drive can be installed in the server in the following ways:
•
Install a diskette drive in the chassis ("Installing a legacy diskette drive" on
page 51)
•
Install a diskette drive using a USB cable (when using operating systems that
support USB) ("Installing a USB diskette drive" on page 52)
IMPORTANT: HP recommends installing the tape drive on a
separate SCSI cable to avoid a decrease in performance on other SCSI
devices.
Advertisement
Table of Contents
