HP ProLiant ML310 Generation 3 User Manual page 36

36 HP ProLiant ML310 Generation 3 Server User Guide
To install the component:
1. Power down the server ("Powering down the server" on page 21).
2. Remove the bezel ("Unlocking the bezel" on page 22).
3. Remove the access panel ("Removing the access panel" on page 22).
4. Disconnect the fan cable from the system board ("System board components"
on page 11).
5. Open the processor retaining bracket.
6. Place the processor into the processor socket.
7. Close the processor locking lever.
8. Prepare the heatsink for installation:
– If reusing the heatsink, clean the bottom of the heatsink with the provided
– If installing a new heatsink, remove the protective covering.
9. Install the heatsink fan assembly.
10. Tighten the four heatsink retaining screws.
CAUTION: To prevent possible server malfunction or damage to
the equipment, be sure to completely close the processor locking lever.
alcohol pad, then apply a thin layer of thermal grease to the top of the
processor.