Cleaning The Pump Filters - Fisher & Paykel WH1160H1 User Manual

Check and clean the pump filters regularly to maintain optimum performance. Some water
may leak from the filters when they are removed. Turn the washer off at the wall before
cleaning these parts.
1
2
3
4
Ensure each filter is placed back into the correct slot and that both filters are correctly in
place before running another cycle.

CLEANING THE PUMP FILTERS

Push the centre of the filter cover to open.
Unhook the outlet hose and pull it out
(approximately 150mm). Remove the plug
and allow any water to drain into a shallow
dish (approximately 250ml).
After draining, replace the plug and refit the
hose back into the housing.
Turn the filters anti-clockwise to remove.
Clean and rinse each filter. Check and clear
the cavity behind each filter. Check the
impeller behind each filter moves freely and
remove any obstructions.
Refit the filters and turn clockwise to secure.
The handles should be in the vertical position.
Do not use excessive force to tighten.
27