Cleaning The Pump Filter - Fisher & Paykel WH1260F1 Quick Start Manual

2. Add the washing machine cleaner to the 'Manual Dose' detergent
compartment when using 'Drum Clean' cycle.
3. Press 'POWER' to turn your washer on and select the 'Drum Clean'
cycle.
4. Touch
to start the cycle.
Cleaning the Drum and the Door
• Use a soft damp cloth to wipe the door, cleaning any water marks or residue off it.
• Wipe the rubber seal around the door. Remove any items or lint accumulating in the bottom of the seal
catchment and wipe out any water accumulated here. If this is not cleaned out, unpleasant odours will develop.
• If the drum has any residual dirt or lint stuck to it, remove this and wipe the drum clean. Do not leave any metal
objects in the drum as these may rust and cause staining.
• The WH1260F1 model has a self cleaning door flush that directs a portion of the rinse water over the door
during various stages of the cycle to help to clean hair and insolubles from the inside of the door and
surrounding parts. We still advise that you manually clean it with a soft cloth periodically as recommended in the
instructions above.

Cleaning the Pump Filter

The pump has a filter to trap foreign objects that enter the washer along with clothing. The pump filter can be accessed
from the front of the washer. The washer will notify you to check the filter every 100 cycles. If this is not addressed it will
become a warning. (Refer to 'Fault Codes')
To clean the filter:
1. Unplug the washer from the power socket on the wall.
2. Use a coin to open the filter cover. Place the edge of
the coin into the slot and tilt upwards whilst levering
the cover open.
3. Unhook the pump outlet hose and pull it out (about
150mm). Remove the plug and allow any water
(approximately 250ml) to drain into a shallow dish.
https://producthelp.fisherpaykel.com/au/Wash/Front_Loaders/FabricSmart/WH1260F1/User_Guide_WH1260F1/13_Caring_fo...
Updated: Tue, 02 Aug 2022 02:36:29 GMT
Powered by
3