To clean the filters at the machine end:
1
Turn off the taps.
2
Disconnect the hose.
3
Clean the filter with a thin brush. If the filter is very dirty, you may clean it by pulling it out with
pliers.
To clean the filters at the tap end:
1
Turn off the taps.
2
Disconnect the hose.
3
Remove the filter by hand.
4
Clean the filter under the tap.
5
Refit hose and turn tap back on.
Hose
To prevent any leakage, it is recommended a technician check the hoses every 2 years.
Drum
Do not leave any metal objects (pins, needles, etc.) inside the drum. These objects may cause
rust on the inside drum surface.
Draining any remaining water and cleaning the pump filter
Your product is equipped with a filter system. This helps extend the pump's life by preventing
solid items such as buttons, coins and fabric fibres from clogging the pump propeller during
discharge of the washing water.
If your machine fails to drain the water, the pump filter may be clogged.
It is recommended that this is cleaned every 30 cycles.
Water must be drained off prior to cleaning the pump filter, or transporting the machine (eg.
when moving house).
Important:
Depending on the program used, there may be water at 90°C in the machine.
The filter must be cleaned only after the inside water is cooled down to avoid a hazard of
scalding.
Care and cleaning
20