Positioning The Seat; Adjusting The Motion Control Levers; Pushing The Machine By Hand - Toro TimeCutter SS 4200 Operator's Manual

2
Figure 20
1. Height-of-cut lever
2. Height-of-cut positions
1. Pull up and inward on the lever to move it to the
desired cutting position.
2. Once at the desired cutting position, slowly lower
the lever until it engages the position.
The transport position is the highest height-of-cut
position or cutting height 4.5 inch [115 mm] (Figure 20).

Positioning the Seat

1. Raise the seat and loosen the adjustment bolts just
enough that seat can move (Figure 21).
1
Figure 21
1. Adjustment bolt
2. Move the seat to the desired position and tighten
the bolts.
3
1
G014476
3. 4.5 inch (115 mm),
Transport position
G014477
Adjusting the Motion Control
Levers
Adjusting the Height
The motion control levers can be adjusted higher or
lower for maximum operator comfort.
1. Remove the 2 bolts holding the control lever to the
control arm shaft (Figure 22).
2. Move the control lever to the next set of holes.
Secure the lever with the 2 bolts (Figure 22).
G014970
1. Control arm shaft
2. Control lever
3. Repeat the adjustment for the opposite control
lever.
Adjusting the Tilt
The motion control levers can be tilted fore or aft for
maximum operator comfort.
1. Loosen the upper bolt holding the control lever to
the control arm shaft.
2. Loosen the lower bolt just enough to pivot the
control lever fore or aft (Figure 22). Tighten both
bolts to secure the control in the new position.
3. Repeat the adjustment for the opposite control
lever.

Pushing the Machine by Hand

Important: Always push the machine by hand.
Never tow the machine because damage may
occur.
This machine has an electric brake mechanism and to
push the machine the ignition key needs to be in the
Run position. The battery needs to be charged and
functioning for the electric brake to be disengage.
20
2
1
3
4
Figure 22
3. Slotted, upper hole
4. Bolt