Leveling The Mower Deck - Toro TimeCutter SS 4200 Operator's Manual

1. Sail area of blade
2. Blade
3. Curved washer
Sharpening the Blades
1. Use a file to sharpen the cutting edge at both ends
of the blade (Figure 46). Maintain the original angle.
The blade retains its balance if the same amount of
material is removed from both cutting edges.
1. Sharpen at original angle
2. Check the balance of the blade by putting it on a
blade balancer (Figure 47). If the blade stays in a
horizontal position, the blade is balanced and can be
used. If the blade is not balanced, file some metal off
the end of the sail area only (Figure 46). Repeat this
procedure until the blade is balanced.
1. Blade
Installing the Blades
1. Install the blade onto the spindle shaft (Figure 45).
Important: The curved part of the blade must
be pointing upward toward the inside of the
mower to ensure proper cutting.
2. Install the blade stiffener, the curved washer (cupped
side toward the blade) and the blade bolt (Figure 45).
3. Torque the blade bolt to 35-65 ft-lb (47-88 N-m).
Figure 45
4. Blade bolt
5. Blade stiffener
Figure 46
Figure 47
2. Balancer

Leveling the Mower Deck

Check to ensure the mower deck is level any time you
install the mower or when you see an uneven cut on
your lawn.
The mower deck must be checked for bent blades
prior to leveling; any bent blades must be removed
and replaced. Refer to the Checking for Bent Blades
procedure before continuing.
The mower deck must be leveled side-to-side first then
the front to rear slope can be adjusted.
Requirements:
• The machine must be on a level surface.
• All four tire must be properly inflated. Refer to
Checking the Tire Pressure in the Drive System
Maintenance section.
Side-to-Side Leveling
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to the
park position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Set the height-of-cut lever to middle position.
4. Carefully rotate the blade(s) so that they are all side
to side (Figure 48).
2
3
4
1. Blades side to side
2. Sail area of blade
5. Measure between the outside cutting edges and the
flat surface (Figure 48 ). If both measurements
are not within 3/16 inch (5 mm), an adjustment is
required; continue with this procedure.
35
1
G009682
2
4
Figure 48
3. Outside cutting edges
4. Measure from the tip of the
blade to the flat surface
here
3