Controls - Toro TimeCutter SS 4200 Operator's Manual

Controls

Become familiar with all of the controls inFigure 4, and
Figure 5 before you start the engine and operate the
machine.
Control Panel
1. Throttle/Choke
2. Ignition switch
Ignition Switch
The ignition switch has three positions, Off, Run and
Start. The key will turn to Start and move back to
Run upon release. Turning the key to the Off position
will stop the engine; however, always remove the key
when leaving the machine to prevent someone from
accidentally starting the engine (Figure 5).
Throttle/Choke Control
The throttle and choke is combined into one control
lever. The throttle controls the engine speed and it has a
continuous variable setting from Slow to Fast. Engage
the choke by moving the lever past the Fast setting until
it stops (Figure 5).
Blade Control Switch (Power Take-Off)
The blade control switch, represented by a power
take-off (PTO) symbol, engages and disengages power
to the mower blades (Figure 5).
Motion Control Levers and Park
Position
The motion control levers are speed sensitive controls of
independent wheel motors. Moving a lever forward or
backward turns the wheel on the same side forward or in
reverse; wheel speed is proportional to the amount the
Figure 5
3. Blade control switch
(power take-off)
lever is moved. Move the control levers outward from
the center to the park position and exit the machine
(Figure 16). Always position the motion control levers
into the park position when you stop the machine or
leave it unattended.
Smart Speed™ Control System Lever
The Smart Speed™ Control System lever, located below
the operating position, gives the operator a choice to
drive the machine at two speed ranges, high and low
(Figure 6).
1. Smart speed lever
Fuel Window
The fuel window located on the left hand side of the
machine can be used to verify the presence of gasoline
in the tank (Figure 7).
G014521
1
1. Fuel presence window
Height-of-Cut Lever
The height of cut lever allows the operator to lower
and raise the deck from the seated position. When the
lever is moved up, toward the operator the deck is raised
from the ground and when moved down, away from the
12
1
G014475
Figure 6
Figure 7