Figure 36. Installing the M.2 SSD module
Next steps
1.
Installing the BOSS-N1
2. Follow the procedure listed in the
Power distribution board
This is a service technician replaceable part only.
Removing the 1U power distribution board
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Disconnect the cables that are connected from cooling fans and system board to the power distribution board (PDB).
NOTE:
Observe the routing of the cable as you remove it from the system.
Steps
1. Using a Phillips 2 screwdriver, remove the screws that secure the PDB to the system.
66
Installing and removing system components
card.
After working inside your
Safety
instructions.
Before working inside your
system.
system.