5.
Install the support
bar.
6. Follow the procedure listed in
7. Install any device drivers required for the card as described in the documentation for the card.
Power distribution board
This is a service technician replaceable part only.
Removing the power distribution board
There are power distribution boards (PDB) on either side of the system. The procedure to remove is similar.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the support
bar.
4.
Remove the air shroud top
5.
Remove the cooling fan cage
6. If required,
Remove the air
7.
Remove the expansion card risers
NOTE:
See
cable routing
8.
Remove the riser air
shroud.
9.
Remove the
PSU.
Steps
1. Loosen the captive screw.
2. Holding the touch point firmly lift the PDB from the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 121. Removing the PDB
After working inside your
Safety
instructions.
Before working inside your
cover.
assembly.
shroud.
or
remove the full length expansion card
section for more information.
system.
system.
riser.
Installing and removing system components
151