Power distribution board
This is a service technician replaceable part only.
Removing the power interposer board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. Remove the PSU.
5. Disconnect the cables that are connected to power interposer board (PIB).
Steps
1. Using a Phillips #2 screwdriver, remove the screws securing the power interposer board (PIB) to the system.
NOTE:
Observe the routing of the cable as you remove it from the system.
2. Lift the PIB away from the system.
Figure 130. Removing the power interposer board
Next steps
Replace the power interposer
Installing the power interposer board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
160
Installing and removing system components
Safety
instructions.
Before working inside your
board.
Safety
instructions.
Before working inside your
system.
system.