Table of Contents
Advertisement
Non-Tactical/Revert for Conventional System
The radio reverts to the programmed emergency channel to send an alarm and/or make an
emergency call.
Non-Tactical/Revert for Trunking System
The radio reverts to the programmed emergency talkgroup (trunking system) or channel
(conventional system) to send an alarm and/or make an emergency call.
For more information, contact your system administrator.
7.10.1
Special Considerations for Emergency Operation
The following scenarios apply during Emergency operation:
Table 6: Emergency Operation Scenarios
Scenario
If you press the Emergency button while in a
channel that has no Emergency capability,
If you change to a channel or mode with no
Emergency capability while in Emergency oper-
ation,
If you change to a channel or mode with Emer-
gency capability while in Emergency operation,
If the radio is out-of-range of the system or the
emergency alarm is not acknowledged,
7.10.2
Emergency Keep-Alive
This feature prevents your radio from turning off when in Emergency mode. If this feature is enabled,
you are required to exit Emergency mode before turning off your radio.
7.10.3
Exiting Emergency Operation
If an Emergency operation is triggered on your radio, the dispatch console or radios configured as
Supervisor can exit the Emergency operation.
Procedure:
To exit Emergency operation, press and hold the programmed Emergency button.
Chapter 7 : Advanced Features
Outcome
a tone sounds.
your radio shows the following indications:
•
A tone sounds until you select a valid Emer-
gency channel or mode, or until you disable
the Emergency operation.
•
The display for Model 3.5 and Model 2.5
shows No emergency.
the Emergency Alarm and/or Emergency Call
continues on the new channel or mode.
your radio shows the following indications:
•
A tone sounds.
•
The display shows No acknowledge.
MN003441A01-AP
67
Advertisement
Table of Contents
