Table of Contents
Advertisement
Name
PixelFormat
PixelFormatInfoSelector
PixelFormatInfoID
PixelSize
PixelColorFilter
ReverseX
ReverseY
MultiROIsInMultiPayloads
Name
AcquisitionMode
AcquisitionStart
AcquisitionStop
AcquisitionArm
AcquisitionFrameRate
TriggerSelector
TriggerMode
TriggerSoftware
TriggerSource
TriggerDelay
ExposureMode
ExposureTimeSelector
ExposureTime
ExposureTimeAbs
ExposureTimeRaw
ExposureAuto
ExposureAutoLimitMax
ExposureAutoLimitMin
STC-MBS312U3V / STC-MCS312U3V / STC-MBS500U3V / STC-MCS500U3V
Product Specifications and Use's Guide
For more information please contact Aegis Electronic Group, Inc. *(888)687-6877 *aegis-g2@aegiselect.com *http://www.aegiselect.com
Description
Format of the pixels provided by the device. It represents all the information provided by
PixelCoding, PixelSize, PixelColorFilter combined in a single feature.
Select the pixel format for which the information will be returned.
Returns the value used by the streaming channels to identify the selected pixel format.
Total size in bits of a pixel of the image.
Type of color filter that is applied to the image.
This feature is used to flip horizontally the image sent by the device. The AOI is applied
after the flipping.
This feature is used to flip vertically the image sent by the device. The AOI is applied
after the flipping.
MultiROIs In MultiPayloads.
Description
Sets the acquisition mode of the device. It defines mainly the number of frames to
capture during an acquisition and the way the acquisition stops.
Starts the Acquisition of the device. The number of frames captured is specified by
AcquisitionMode.
Stops the Acquisition of the device at the end of the current Frame. It is mainly used
when AcquisitionMode is Continuous but can be used in any acquisition mode.
Arms the device before an AcquisitionStart command. This optional command validates
all the current features for consistency and prepares the device for a fast start of the
Acquisition.
Controls the acquisition rate (in Hertz) at which the frames are captured.
Selects the type of trigger to configure.
Controls if the selected trigger is active.
Generates an internal trigger. TriggerSource must be set to Software.
Specifies the internal signal or physical input Line to use as the trigger source. The
selected trigger must have its TriggerMode set to On.
Specifies the delay in microseconds (us) to apply after the trigger reception before
activating it.
Sets the operation mode of the Exposure (or shutter).
Selects which exposure time is controlled by the ExposureTime feature. This allows for
independent control over the exposure components.
Sets the Exposure time when ExposureMode is Timed and ExposureAuto is Off. This
controls the duration where the photosensitive cells are exposed to light.
Sets the Exposure time when ExposureMode is Timed and ExposureAuto is Off. This
controls the duration where the photosensitive cells are exposed to light.
Sets the Exposure time when ExposureMode is Timed and ExposureAuto is Off. This
controls the duration where the photosensitive cells are exposed to light.
Sets the automatic exposure mode when ExposureMode is Timed. The exact algorithm
used to implement this control is device-specific.
Determine the upper limit of exposure time when ExposureAuto is set to Continuous.
Determine the lower limit of exposure time when ExposureAuto is set to Continuous.
No.16S024-02
58/64
Advertisement
Table of Contents
