Table of Contents
Advertisement
Name
RegionSelector
RegionMode [RegionSelector]
Width [RegionSelector]
Height [RegionSelector]
OffsetX [RegionSelector¥
OffsetY [RegionSelector]
ComponentSelector
ComponentEnable
[ComponentSelector]
PixelFormat [ComponentSelector]
PixelFormatInfoSelector
PixelFormatInfoID
[PixelFormatInfoSelector]
PixelSize [ComponentSelector]
PixelColorFilter [ComponentSelector]
ReverseX
ReverseY
PriorityMode
Name
AcquisitionMode
AcquisitionStart
AcquisitionStop
AcquisitionArm
AcquisitionFrameRate
TriggerSelector
TriggerMode [TriggerSelector]
TriggerSoftware [TriggerSelector]
TriggerSource [TriggerSelector]
TriggerDelay [TriggerSelector]
ExposureMode
ExposureTimeSelector
STC-LBS34U3V-SWIR
Product Specifications and User's Guide
Description
Selects the Region of interest to control. The RegionSelector feature allows devices that
are able to extract multiple regions out of an image, to configure the features of those
individual regions independently.
Controls if the selected Region of interest is active and streaming.
Width of the image provided by the device (in pixels).
Height of the image provided by the device (in pixels).
Horizontal offset from the origin to the region of interest (in pixels).
Vertical offset from the origin to the region of interest (in pixels).
Selects a component to activate data streaming from.
Controls if the selected component streaming is active.
Format of the pixels provided by the device. It represents all the information provided by
PixelCoding, PixelSize, PixelColorFilter combined in a single feature.
Select the pixel format for which the information will be returned.
Returns the value used by the streaming channels to identify the selected pixel format.
Total size in bits of a pixel of the image.
Type of color filter that is applied to the image.
This feature is used to flip horizontally the image sent by the device. The AOI is applied
after the flipping.
This feature is used to flip vertically the image sent by the device. The AOI is applied
after the flipping.
Select image output priority.
Description
Sets the acquisition mode of the device. It defines mainly the number of frames to
capture during an acquisition and the way the acquisition stops.
Starts the Acquisition of the device. The number of frames captured is specified by
AcquisitionMode.
Stops the Acquisition of the device at the end of the current Frame. It is mainly used
when AcquisitionMode is Continuous but can be used in any acquisition mode.
Arms the device before an AcquisitionStart command. This optional command validates
all the current features for consistency and prepares the device for a fast start of the
Acquisition.
Controls the acquisition rate (in Hertz) at which the frames are captured.
Selects the type of trigger to configure.
Controls if the selected trigger is active.
Generates an internal trigger. TriggerSource must be set to Software.
Specifies the internal signal or physical input Line to use as the trigger source. The
selected trigger must have its TriggerMode set to On.
Specifies the delay in microseconds (us) to apply after the trigger reception before
activating it.
Sets the operation mode of the Exposure (or shutter).
Selects which exposure time is controlled by the ExposureTime feature. This allows for
independent control over the exposure components.
No. 22S036-00
48/54
Advertisement
Table of Contents
