Approved, Fulfilled Or Tested Standards - Pulse DIMENSION CP Series Manual

CP-Series
19. A , F
PPROVED ULFILLED OR
IEC 61010-2-201
UL 61010-2-201
IEC 62368
ATEX
(except CP5.241-C1, CP5.242)
IECEx
(except CP5.241-C1, CP5.242)
Class I Div 2
(except CP5.242)
IEC 61558-2-16
SEMI F47
VDMA 24364
Jul. 2022 / Rev. 1.2 DS-CP5.241-EN All parameters are typical values specified at 230Vac, 50Hz input voltage, 24V, 5A output load,
25°C ambient and after a 5 minutes run-in time unless otherwise noted.
CP5.241, CP5.241-C1, CP5.241-S1,
T S
ESTED TANDARDS
CB Scheme Certificate
Electrical Equipment for Measurement, Control and Laboratory Use - Particular
requirements for control equipment
UL Certificate
Listed equipment for category NMTR - Electrical Equipment for Measurement,
Control and Laboratory Use - Particular requirements for control equipment
Applicable for US and Canada
E-File: E198865
CB Scheme Certificate
IEC 62368-1 Audio/video, information and communication technology equipment
- Safety requirements
Output safety level: ES1
Agency Certificate (Bureau Veritas)
EN 60079-0 Explosive atmospheres - General requirements
EN 60079-7, EN 60079-15 Equipment protection by type of protection "e" and "n"
Certificate: EPS 19 ATEX 1 201 X
Temperature Code: T4
Type of Protection: ec nC
IECEx Certificate
IEC 60079-0 Explosive atmospheres - General requirements
IEC 60079-7, IEC 60079-15 Equipment protection by type of protection "e" and
"n"
Certificate: IECEx EPS 19.0078X
Temperature Code: T4
Type of Protection: ec nC
UL Certificate
Listed equipment for category NRAD - Listed equipment Industrial Control
Equipment for Use in Hazardous Locations
Applicable for US and Canada
E-File: E327416
Temperature Code: T4
Groups: A, B, C and D
Test Certificate
Safety of transformers, reactors, power supply units and similar products for
supply voltages up to 1100 V
Particular requirements and tests for switch mode power supply units and
transformers for switch mode power supply units
Test Report
Voltage Sag Immunity for Semiconductor Processing Equipment
Tested for AC 208V L-L or L-N mains voltages, nominal output voltage and
nominal output load
Paint Wetting Impairment Substances Test (or LABS-Test)
Tested for Zone 2 and test class C1 according to VDMA 24364-C1-L/W for solvents
and water-based paints
www.pulspower.com Phone +49 89 9278 0 Germany
CP5.241-S2, CP5.242
24V, 5A, 120W, S
INGLE
P I
HASE NPUT
19/30