Cisco Catalyst 9500 Manual page 88

Configuring a Scheduled Software Image Reload
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
72
Command or Action
configure terminal
Example:
Device# configure terminal
copy running-config startup-config
Example:
Device# copy running-config
startup-config
reload in [hh:]mm [text]
Example:
Device# reload in 12
System configuration has been modified.
Save? [yes/no]: y
reload at hh: mm [month day | day month] [text]
Example:
Device(config)# reload at 14:00
reload cancel
Example:
Device(config)# reload cancel
show reload
Example:
show reload
Performing Device Setup Configuration
Purpose
Enters global configuration mode.
Saves your device configuration information to
the startup configuration before you use the
reload command.
Schedules a reload of the software to take affect
in the specified minutes or hours and minutes.
The reload must take place within
approximately 24 days. You can specify the
reason for the reload in a string up to 255
characters in length.
Specifies the time in hours and minutes for the
reload to occur.
Use the at keyword only if the
Note
device system clock has been set
(through Network Time Protocol
(NTP), the hardware calendar, or
manually). The time is relative to
the configured time zone on the
device. To schedule reloads across
several devices to occur
simultaneously, the time on each
device must be synchronized with
NTP.
Cancels a previously scheduled reload.
Displays information about a previously
scheduled reload or identifies if a reload has
been scheduled on the device.