13.24
Removing fork protector
13.25
Installing the fork protector
13.26
Cleaning the dust boots of the fork legs
–
Remove screws
–
Remove screw
–
Take off the fork protector at the front.
–
Repeat these steps on the opposite side.
F02051-10
–
Position the fork protector. Mount screw
tighten yet.
Guideline
Screw, fork protector
–
Mount screws
Guideline
Screw, fork protector
The fork protector is evenly aligned to the front.
F02051-11
–
Tighten all screws of the fork protector.
Guideline
Screw, fork protector
Screw, fork protector
–
Repeat these steps on the opposite side.
Preparatory work
–
Raise motorcycle with rear lifting gear. (
–
Remove the front fender. (
–
Lift the motorcycle with the front lifting gear. (
Main work
–
Push dust boots
Info
The dust boots remove dust and coarse dirt particles
from the inside fork tubes. Over time, dirt can accumu-
late behind the dust boots. If this dirt is not removed,
the oil seals behind can start to leak.
F02053-10
SERVICE WORK ON THE CHASSIS 13
1
.
2
.
1
M5x12
5 Nm (3.7 lbf ft)
2
, but do not tighten yet.
M5x17
5 Nm (3.7 lbf ft)
M5x12
5 Nm (3.7 lbf ft)
M5x17
5 Nm (3.7 lbf ft)
p. 94)
1
of both fork legs downward.
, but do not
p. 81)
p. 81)
95