Stopping, Parking - KTM 790 ADVENTURE R 2022 Owner's Manual

10 RIDING INSTRUCTIONS
–
Always finish the braking before you go into a bend. Shift down to a lower gear appropriate to your speed.
–
Use the braking effect of the engine on long downhill stretches. To do so, shift back one or two gears, but do
not overrev the engine. This means that significantly less braking is required and the brake system does not
overheat.
10.7
Note
Material damage The vehicle may be damaged by incorrect procedure when parking.
Significant damage may be caused if the vehicle rolls away or falls over.
The components for parking the vehicle are designed only for the weight of the vehicle.
–
Park the vehicle on a firm and level surface.
–
Ensure that nobody sits on the vehicle when the vehicle is parked on a stand.
Note
Fire hazard Hot vehicle components pose a fire hazard and explosion risk.
–
Do not park the vehicle near to materials which are highly flammable or explosive.
–
Allow the vehicle to cool down before covering it.
–
Apply the brakes on the motorcycle.
–
Shift the transmission into neutral
–
Switch off the ignition by turning the ignition key to the position
–
Park the motorcycle on a firm surface.
–
Swing side stand forward with your foot as far as it will go and lean the vehicle on it.
–
Lock the steering by turning the handlebar fully to the left, pressing down the ignition key to the position
and turning it to the position
the left and right. Remove the ignition key.
70
Warning
Danger of accidents Banked or laterally sloping ground reduces the maximum possible delay.
–
If possible finish braking before going into a bend.

Stopping, parking

Warning
Risk of injury People who act without authorization endanger themselves and others.
–
Do not leave the vehicle unattended if the engine is running.
–
Protect the vehicle against access by unauthorized persons.
–
Lock the steering and remove the ignition key if you leave the vehicle unattended.
Warning
Danger of burns Some vehicle components become very hot when the vehicle is operated.
–
Do not touch any parts such as the exhaust system, radiator, engine, shock absorber, or brake system
before the vehicle parts have cooled down.
–
Let the vehicle parts cool down before you perform any work on the vehicle.
Info
If the engine is switched off with the emergency OFF switch and the ignition remains switched on at
the ignition lock, power continues to flow to most electrical power consumers. This discharges the 12-
V battery. You should therefore always switch off the engine with the ignition lock – the emergency
OFF switch is intended for emergencies only.
. To make the steering lock engage more easily, move the handlebar a little to
.
.