Department Group Projection; Hourly Report - Sharp UP-3500 Instruction Manual

I I I I I Department group projection
(1) Select the PGM2 mode and touch the [2 POS SETTING] to perform the programming.
(2) Touch the [7 TERMINAL] button to display the menu, and touch the [1 REPORTS] button to display the
detail menu. Then touch the [3 DEPT GR. PROJECTION] button to program the group projection.
(3) Touch the required programming item, and enter each group number and touch the [ENTER] key.
Repeat this step (3) satisfactorily.
(4) To terminate the programming, touch the [EXIT] key.
Text
DEPT GR. No.#1
DEPT GR. No.#2
:
:
DEPT GR. No.#25
I I I I I Hourly report
(1) Select the PGM2 mode and touch the [2 POS SETTING] to perform the programming.
(2) Touch the [7 TERMINAL] button to display the menu, and touch the [1 REPORTS] button to display the
detail menu. Then touch the [4 HOURLY REPORT] button to program for the hourly report.
(3) Touch the required programming item, and select or enter each parameter and touch the [ENTER] key.
Repeat this step (3) satisfactorily.
(4) To terminate the programming, touch the [EXIT] key.
Text
MEMORY TYPE
STARTING TIME
START TIME AM/PM
• This setting effect both setting to HOURLY, LABOR COST% REPORT.
• This setting effect only starting time to SERVICE TIME REPORT.
214
➝
(7 TERMINAL
Dept group no. 1 : max. 2 digits (1 to 99/0)/ (0: undefined)
Dept group no. 2 : max. 2 digits (1 to 99/0)/ (0: undefined)
Dept group no. 25 : max. 2 digits (1 to 99/0)/ (0: undefined)
➝
(7 TERMINAL 1 REPORTS
Memory type;
15MIN: 15-minute type
30MIN: 30-minute type
60MIN: 60-minute type
Starting time: max. 2 digits (1 to 12)
Starting time (AM/PM selection);
AM:
PM:
➝
1 REPORTS 3 DEPT GR. PROJECTION .......... PGM2)
Parameter
:
:
➝
4 HOURLY REPORT .......... PGM2)
Parameter