Vivax ACP-12CH35AEHI+ R32 User Manual page 240

VIVAX
Note: You can only activate this function in COOL or DRY mode.
Turbo Function
Press TURBO Button.
 When you select Turbo feature in COOL/ HEAT mode, the unit will
blow cool air with strongest wind setting to jump-start the
cooling/heating process.
SET Function
Press the SET button to enter the function setting, then press SET
button or TEMP ▼ or TEMP ▲ button to select the desired function.
The selected symbol will flash on the display area, press the OK
button to confirm.
To cancel the selected function, just perform the same procedures as
above.
Press the SET button to scroll through operation functions as follows:
FRESH  SLEEP*  FOLLOW ME  AP mode
*: If your remote controller has Fresh and Sleep button, you can not use
the SET button to select the Fresh and Sleep feature.
Fresh function
When the FRESH function is initiated, the ion generator is energized and
will help to purify the air in the room.
Sleep function
The SLEEP function is used to decrease energy use while you sleep (and
don't need the same temperature settings to stay comfortable).
AP function
Choose AP mode to do wireless network configuration. For some units,
it doesn't work by pressing the SET button. To enter the AP mode,
continuously press the LED button seven times in 10 seconds.
Follow me function
The FOLLOW ME function enables the remote control to measure the
temperature at its current location and send this signal to the air
conditioner every 3 minutes interval. When using AUTO, COOL or HEAT
modes, measuring ambient temperature from the remote control (instead
of from the indoor unit itself) will enable the air conditioner to optimize the
temperature around you and ensure maximum comfort.
NOTE: Press and hold Turbo button for seven seconds to start/stop
memory feature of Follow Me function.
36
ENG