Figure 14: Major Component Descriptions - High Efficiency Reflector - Roberts Gorden ENERGYTUBE AG Series Installation, Operation & Service Manual

AG-S I , O
ERIES NSTALLATION PERATION AND

FIGURE 14: Major Component Descriptions - High Efficiency Reflector

Burner Tube
Supplied in 10' (3 m) lengths.
Burner tube is always the first
tube after the burner.
Tube and Reflector Hanger
with Clamp Package-EF
Position this hanger no more
than 4" (10 cm) away from
the burner.
Tube and Reflector Hanger-EF
Suspend system from these
hangers.
Reflector Support Strap &
Wire Form
Flex Gas Line with
Shut Off Cock
12 of 57
S M
ERVICE ANUAL
Burner with Tube
Gasket
Must be installed with
the flame observation
window facing down.
High Efficiency Reflector
(Aluminum or Stainless Steel)
Alternate
overlap as
shown on
overview
and Page 19, Figure 17.
Minimum overlap is 6" (16 cm).
Tube
Hot rolled or heat
treated aluminized tube
supplied in 10' (3 m) lengths.
Vent Adapter
Install turbulator
as specified in the
"Turbulator Installation" chart.
See Page 22, Step 6.4.
Turbulator is not required on the
AG-175.
Coupling Assembly
with Lock
Reflector End Cap-EF
Punch out center
section to
accommodate tube.
Turbulator