Roberts Gorden ENERGYTUBE AG Series Installation, Operation & Service Manual page 55

Blower Scroll, Wheel and
Motor
Burner Cup and Orifice
Electrode
Thermostat
Suspension Points
Decorative and Protective
Grille (optional)
Lower Clearance Shield
(optional)
Wall Tag
Safety Labels
Compressed air or a vacuum cleaner may be used to clean dust and dirt.
Clear of obstructions (even spider webs will cause problems).
Carefully remove any dust and debris from the burner.
Replace if there are cracked ceramics, excessive carbon residue, or erosion
of the electrode.
The electrode gap should be 1/8" (3.2 mm).
There should be no exposed wire or damage to the thermostat.
See Page 44, Section 10.
Make sure the heater is hanging securely. Look for signs of wear on the chain
or ceiling.
See Page 17 , Figure 15.
The grille must be securely attached.
Check that the side reflector extensions are installed correctly and secured in
place if necessary. (Decorative grille only.)
See Page 32, Section 7 .5 and Page 34, Section 8
Make sure shield is installed correctly and secured in place if necessary.
(Decorative grille only.) See Page 33, Section 7 .5.2.
The lower shield must be securely attached. Inspect shield support straps
and lower clearance shield anchor points.
See Page 32, Section 7 .4.
Make sure shield is installed correctly and secured in place if necessary.
See Page 32, Section 7 .4.
If wall tag is present, make sure it is legible and accurate. Please contact
Roberts-Gordon LLC or your ROBERTS GORDON
you need a wall tag. See Page 4, Section 2.1
Product safety signs or labels should be replaced by the product user when
they are no longer legible. Please contact Roberts-Gordon LLC or your
ROBERTS GORDON
®
labels. See Page 2, Figure 1 through Page 3, Figure 2.
independent distributor to obtain replacement signs or
SECTION 11: O M
PERATION AND AINTENANCE
® independent distributor, if
49 of 57