Roberts Gorden ENERGYTUBE AG Series Installation, Operation & Service Manual page 30

AG-S I , O
ERIES NSTALLATION PERATION AND
Step 6.5.1 Reflector, U-Clip and Reflector Support Installation
The pictorial drawings of the heater construction in
Section 6 are schematic only and provide a general
guideline of where hangers, reflector supports and
U-clips are to be installed.
To ensure proper expansion and contraction
movement of the reflectors, a combination of U-clips
and reflector supports are used. The positioning of
Description
Reflector Support Package
Wire Form
Reflector Support Strap, Wide Pattern
Screw #8 x 3/4"
U-Clip Package
Reflector End Cap
24 of 57
S M
ERVICE ANUAL
Part Number
0305001X
91908004
0305000X
94320812
91107720
027508XX
reflector supports and U-clips depend on the
individual installation. Use either pop rivets or sheet
metal screws instead of u-clips when installing end
caps and joint pieces in areas where impact and high
wind may be a factor. The following rules must be
observed.