Table of Contents
Advertisement
FOR YOUR SAFETY, READ BEFORE LIGHTING.
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION
MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.
A. This appliance is equipped with an ignition
device which automatically lights the pilot.
Do not try to light the pilot by hand.
B. BEFORE LIGHTING, smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle to the floor.
WHAT TO DO IF YOU SMELL GAS:
• Extinguish any open flame.
• Open windows.
• Do not light any appliance.
• Do not touch any electrical switches.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone.
• If your gas supplier cannot be reached, call
the fire department.
1. STOP! Read the safety information above.
2. Set the thermostat to the lowest setting.
3. Set the Burner Control Switch to the "OFF"
position.
4. This appliance is equipped with an ignition
device which automatically lights the pilot.
Do not try to light the pilot by hand.
ON
OFF
TSTAT
MODE CONTROLS
5. Wait five (5) minutes to clear out any gas.
Then, smell for gas, including near the
floor. If you smell gas, STOP! Follow "B" in
the safety information above on this label.
If you do not smell gas, go to the next
step.
TO TURN OFF GAS TO THE APPLIANCE:
1. Set the thermostat to the lowest setting.
2. Turn off all electric power to the appliance if
service is to be performed.
CAUTION:
Do not operate this appliance
with the glass removed, cracked or broken. Replace-
ment of the glass panel shall be done by a licensed
or qualified serviceperson.
LIGHTING INSTRUCTIONS
WARNING:
LIGHTING INSTRUCTIONS
7. Set the Burner Control Switch to the "TSTAT"
8. Set the thermostat to the desired setting to
9.
C. Use only your hand to push in or turn the
gas control knob. Never use tools. If the
knob will not push in or turn by hand,
do not try to repair it. Call a qualified
technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part has
been under water. Immediately call a
qualified service technician to inspect the
appliance and to replace any part of the
control system and any gas control which
has been under water
.
6. Set the Burner control switch to "ON". The
pilot will light the burner.
CPI MODE: The pilot will burn continuously
for up to seven (7) days.
IPI MODE: The pilot will ignite only when
there is a manual or thermostatically-
controlled call for heat. It will shut off
together with the burner.
position for thermostatic control.
light the burner.
If the appliance will not operate, follow the
instructions "To Turn Off Gas To Appliance",
and call your service technician or gas
supplier.
3. Set the Burner Control Switch to the
"OFF" position.
4. Close control access door.
CAUTIONNER:
l'appareil si le panneau frontal en verre n'est pas
en place, est craqué ou brisé. Confiez le remplace-
ment du panneau à un technicien agrée.
139177-V GI 450 DVII 11/20
PILOT LIGHT
Ne pas utiliser
35
Advertisement
Table of Contents
