Chapter 7: Troubleshooting - Toro 68037G Operator's Manual

The machine does not drive.
The machine has been inactive for more
than 30 seconds and is in sleep mode.
One or more of the electrical connections
are loose.
The machine does not start.
The batteries need to be charged.
The electrical service disconnect switch is in
the position.
OFF
The emergency stop switch is engaged.
The machine batteries do not charge.
The electrical service disconnect switch is in
the position.
OFF
The charging cord plug is not fully plugged
in.
The charger is bad.
The throttle is not working properly.
The throttle needs to be calibrated.
3465-683 A
Possible Cause
Possible Cause
Possible Cause
Possible Cause
Troubleshooting
Set the drive control in the
and back to the preferred direction.
Check and tighten any loose connections.
1. Check the InfoCenter for the battery
status.
2. Charge the machine.
Turn the electrical service disconnect switch
to the position.
ON
Disengage the emergency stop switch.
Turn the electrical service disconnect switch
to the position.
ON
Ensure that both sides of the charging cord
is fully plugged in.
Contact your Authorized Service Dealer.
Calibrate the throttle.
Page 7–1
Chapter 7
Corrective Action
NEUTRAL
Corrective Action
Corrective Action
Corrective Action
position
Troubleshooting