Chapter 4: Operation; Before Operation; Before Operation Safety - Toro 68037G Operator's Manual

Before Operation

Before Operation Safety

Before Operation General Safety
• Never allow children or untrained people to operate the machine. Local regulations may
restrict the age of the operator. The owner is responsible for training all operators and
mechanics.
• Keep bystanders and children out of the operating area. Allow only people who are
responsible, trained, familiar with the instructions, and physically capable to operate the
machine.
• Become familiar with the safe operation of the equipment, operator controls, and safety
signs.
• Inspect the area where you will use the machine and remove all objects that could
interfere with the operation of the machine.
• Know and mark the locations of all utility lines.
• Check that the operator's presence controls, safety switches, and shields are attached
and functioning properly. Do not operate the machine unless they are functioning
properly.
• Locate the pinch point areas marked on the machine and keep hands and feet away from
these areas.
• Before each work shift, inspect the machine components: the tires; warning devices;
lights; battery; speed and directional controllers; brakes; safety interlocks; and steering
mechanism. If the machine needs repair or is in any way unsafe, report it immediately
and do not use the machine until it has been restored to safe operating condition.
• Identify sharp turns, blind spots, bridge approaches, and other potentially hazardous
areas with a suitable warning to operators of the nature of the hazard and stating the
proper precautions for them to take to avoid the hazard.
• Use only an approved machine in hazardous locations, as defined in the appropriate
safety standards.
• Do not carry passengers on the machine and keep bystanders and children out of the
operating area.
• Ensure that the area is clear of bystanders before operating the machine. Shut off the
machine if a bystander enters the area.
• Keep away from potential hazards, such as edges of ramps and platforms.
3465-683 A Page 4–1
Chapter 4
Operation
Operation