CYBEX Eagle Abdominal Owner's Manual page 13

5. Lean guide rods outward, away from machine in order to provide the most room for installing
weight plates.
6. Slide top weight up and out of machine and carefully set it aside.
7. Wipe guide rods clean over entire length. Lubricate with light coating of medium weight
automotive engine oil.
8. Install each weight plate one at a time. When installing weight plates, position plates so wide
edges of bushing face upward and narrow edges of bushing face downward.
9. Slide top weight onto guide rods.
10. Place lower snap ring and wave washer onto guide rod (about 3" from the top end of guide
rod.)
11. Raise guide rod up through mounting hole and install the upper snap ring.
12. Lower guide rod and secure lower snap ring. Repeat for the opposite guide rod.
Cybex Owner's Manual
WIDE bushing
edge faces
upward
13
NOTE: The narrow
bushing edge must
face downward.
NARROW
bushing edge