CYBEX Eagle Abdominal Owner's Manual page 12

4. Lift top weight and turn the Increment Weight Adjusting Knob to select 15 lbs (three
increment weights each side.)
5. Remove the three Phillips head screws securing the top (back) shroud and carefully remove
the shroud.
6. Loosen but do not remove bottom two screws.
7. Remove the top two screws securing the back shroud.
8. Slide rear shroud assembly upward and remove.
Install the weight stack
1. Note how the increment weights are installed.
2. With an assistant holding the increment weights, move the adjusting knob to 0 lbs and
remove all six increment weights (three each side.)
3. Using an external snap ring pliers, remove the upper snap ring from one of the guide rods
and carefully lower the guide rod.
4. Remove lower snap ring and wave washer from the guide rod. Repeat for the opposite guide
rod.
Cybex Owner's Manual
Screw (loosen -
do not remove)
Frame
Guide rod
Phillips Head
Screw (3)
Screw
Upper snap ring
Wave washer
Lower snap ring
12