CYBEX Eagle Abdominal Owner's Manual page 11

11. Attach each half together using the six BHSCS that were removed.
12. Attach pulley shaft using the pivot shaft and BHSCS that were removed.
13. Reconnect belt to cam and reinstall pulley.
14. Connect other end of belt to the arm using the BHSCS and nylon locknut.
15. Connect the weight stack belt to the belt clamp of cam that was removed.
Install rubber feet
1. Remove each (standard) cone-shaped shipping support using a 3/4" socket or wrench.
2. Cut shipping tie securing top weight.
3. Place rubber feet (supplied with machine) on each foot of the frame.
Cybex Owner's Manual
BHSCS (qty 6)
Nylon Locknut (6)
BHSCS
Pulley/Cable
Pivot Shaft
Shoulder
Hex
Bolt
Nut
Cam
11
Washer
Pulley Shaft
Set
Screws