Table of Contents
Advertisement
Qty
1
14
Move to desired location
1. Determine if you can move your machine through the required doorway(s).
2. If the machine fits through the doorway(s), move machine to desired location.
3. Attach rubber feet to each foot of the frame.
4. If weight stacks need to be installed follow procedure for installing weight stacks.
5. If the machine does not fit through the doorway(s) follow doorway procedures below.
Doorway Instructions
1. Remove each (standard) cone-shaped shipping support using a 3/4" socket or wrench.
2. Make a note of the current belt routings and connections. This will assist you in reinstalling
them properly.
3. Cut shipping tie securing top weight.
4. Rotate cam and disconnect weight stack belt from cam (by loosening the two set screws on
the belt clamp with a 7/32" Allen wrench.)
5. Locate the belt attached to the pivot shaft. Remove the shoulder bolt and hex nut securing
belt to the pivot arm.
Cybex Owner's Manual
Part Number
12000-560
4000C101
Cam
Shoulder
Bolt
9
Description
Decal, Weight Plate
(30-290)
Weight Stack Plate
Set
Screws
Hex
Nut
Diagram
NOTES:
1. RIGHT HAND SIDE - 40 POINT HELVETICA BOLD.
HORIZONTAL SCALE 80%.
MATERIAL:
EXCEPT AS NOTED
TRACKING -50.
DIMENSIONS
REMOVE ALL BURRS
IN INCHES
BREAK SHARP EDGES
2. LEFT HAND SIDE - 48 POI NT FUTURA CONDENSED BOLD.
THIS NOTE REFERS TO ALL PLASTIC PARTS
GENERAL
.005/.010 R
TITLE:
AND ASSEMBLIES CONTAINING PLASTICS.
TOLERANCES:
SURFACE FINISH
DECAL, WT PLATE (30 - 290)
RAW MATERIAL AND COMPONENTS ON
INDICATED PER
SUB-ASSEMBLIES AND ASSEMBLIES MUST
2 DECIMALS ± .03
3 DECIMALS ± .015
ANSI B46.1-1985
DWG. BY
DATE
COMPLY WITH EUROPEAN DIRECTIVE
ANGLES ± 1°
REMOVE CARBURIZATION
REL
9/14/05
RoHS 2002/95/EC.
AND SCALE FROM LASER
FEATURES SHOWN
AND PLASMA CUT EDGES
CHECKED BY
DATE
FINISH:
PERPENDICULAR OR
PARALLEL SHALL BE
GENERAL
125
SIZE
SCALE
SHEET
DWG. NO.
SO WITHIN ± 1°
MACHINING
B
1:1
2
OF
2
OWATONNA
TECH. PUBS. APPR.
DATE
BB
9/16/05
MFG. APPR.
DATE
12000-560
REV.
Advertisement
Table of Contents
