Misfeed In The Paper Feed Area - Sharp MX-M550 Operation Manual

MISFEED REMOVAL

Misfeed in the paper feed area

NOTE
Be sure to follow the misfeed removal sequence. Do not pull the tray out immediately as the misfeed may have
occurred with paper partially fed out of the tray. Open the left cover and see if there is misfed paper first (steps 1
and 2). If you open the tray without checking, the partially fed paper may tear and leave torn pieces in the machine,
increasing the difficulty of removal.
■ Misfeed in paper tray 1 - tray 2
1 Remove the duplex unit.
2 Remove the misfed paper.
Roller rotating knob A
NOTE
A misfeed may occur inside the compartment, so
please check the entire compartment carefully.
3 If misfed paper is not found in step 2, pull
out paper tray 1 - tray 2 and remove the
misfed paper.
●If paper is misfed in tray 1 (left-side tray)...
2-26
Grasp the finger hold
and gently open the unit.
Turn roller rotating knob
A in the direction of the
arrow to remove the
misfed paper.
Grasp the finger hold
and gently open the unit.
Pull the tray all the way
out until it stops.
Lift the paper guide and
remove the misfed
paper.
Be sure to replace the
paper guide in its
original position after
removing the paper.
●If paper is misfed in tray 2 (right-side tray)...
Gently close paper tray 1 - tray 2.
4
5 Gently close the duplex unit.
When using tray 2,
check the paper transfer
unit inside the tray and
remove any misfed
paper.
Push the tray all the way
back in.
After closing, confirm
that the misfeed
message has been
cleared and the normal
display appears.