Sharp MX-M550 Operation Manual page 60

MISFEED REMOVAL
■ Misfeed in the tray 5 (AR-LC7)
If a paper misfeed occurs, follow the steps below to remove the misfeed.
1 Open the side cover.
Remove the misfed paper.
2
3 Gently close the side cover.
4 Close the bypass tray.
5 Open the top cover of the AR-LC7 (tray 5).
2-30
Be careful not to tear
the misfed paper
during removal.
Hold the top cover
open.
6 Remove the misfed paper.
7 Pull out tray 1 - tray 2.
NOTE
If a misfeed occurs in the following situation, push tray
1 - tray 2 back in and then pull the tray out again:
● A misfeed occurs during printing from tray 5 (AR-
LC7) while paper is being loaded in tray 1 - tray 2.
8 Remove the misfed paper.
9 Gently push tray 1-tray 2 into the machine.
Be careful not to tear
the misfed paper
during removal.
After removing the
misfed paper, close the
top cover.
Grasp the finger hold
and gently open the
tray.
Pull the tray all the way
out until it stops.
Check the paper
transfer unit inside the
tray. If there is a
misfeed in the paper
transfer unit, remove
the misfeed.
Push the tray firmly all
the way into the
machine.
Make sure that the
misfeed message no
longer appears (the
normal message
display should appear).