Sharp MX-M550 Operation Manual page 63

Hide thumbs Also See for MX-M550:
Table of Contents

Advertisement

Problem
The paper size and paper type have not
been set.
Paper
from
the
bypass
tray
The number of sheets placed on the bypass
misfeeds.
tray exceeds the maximum number.
The bypass guide is not adjusted to the
size of the loaded paper.
If too many pages collect on the output
Printing
stops
tray, the tray full sensor activates and
before the job is
stops printing.
finished.
The paper tray is out of paper.
Smudges on printed
Does a message appear indicating the
sheets
need for maintenance?
The displayed paper
size or paper type
The correct paper size or paper type is
does not match the
not set in the paper tray settings of the
loaded paper size or
system settings.
paper type.
When printing on a
special
size
of
The paper size setting is not set
paper, part of the
correctly in the paper tray settings of the
printed
image
is
system settings.
missing.
When printing on a
special size of paper
using the bypass
The paper size is not set correctly in the
tray, part of the
special size settings for the bypass tray.
printed
image
is
missing.
Is
recommended paper being used?
Paper curled or damp?
Is the paper curled and does it
frequently misfeed in the finisher or
saddle stitch finisher?
Paper
misfeeds
frequently.
Multiple
simultaneously?
The paper in the tray is not stacked
evenly.
Check
paper
other
than
sheets
of
paper
Solution or cause
Be sure to set the paper size and paper type
when using special size or special type papers.
(Page 2-14)
Do not place more than the maximum number of
sheets.
Adjust the bypass guide to the size of the loaded
paper.
Remove the paper from the output tray.
Load paper. (Page 2-2)
Please contact your dealer as soon as possible.
When loading paper, if you change the paper
size from an inch size to an AB size, or from an
AB size to an inch size, or change the paper
type, be sure to set the new paper type as
explained in "Setting the paper type and paper
size" (see page 2-14).
When using a special size of paper, set the
correct paper size as explained in "Setting the
paper type and paper size" on page 2-14. If the
paper size setting is not correct, part of the image
may be cut off or the image may not be printed.
When using a special size of paper, set the
correct paper size as explained in "Setting the
paper type and paper size" on page 2-14. If the
paper size setting is not correct, part of the image
may be cut off or the image may not be printed.
SHARP-
Use SHARP-recommended paper. (Page 2-22)
Do not use curled or crimped paper. If you will
not use the paper for a long time, remove the
paper from the tray and store it in the wrapper in
a cool and dark location so that it will not absorb
moisture.
Paper may be curled when output depending on
the paper type and quality.
In some cases turning the paper over in the tray
will reduce misfeeding due to curling.
fed
Make sure that the paper in the paper tray is
stacked evenly. If the stack is not even, paper
misfeeds will occur.
TROUBLESHOOTING
Remove the paper
from the paper
tray or the bypass
tray, fan the paper
as shown in the
illustration,
and
then load it again.
2-33
2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents