Samsung NX58K9500WG User Manual page 45

Maintenance
CAUTION
• Do not leave racks in the oven during the self-cleaning cycle. The extreme heat
generated in this cycle can permanently peel off the rack coating and make it
difficult to remove the rack.
• Do not spray cooking oil or lubricant directly onto the gliding rack.
Oven
Door
Do not remove the inner gasket of the oven door for cleaning.
Inner side
• Inner surface: Clean the inner side of the door manually using a soapy plastic
scouring pad, and then wipe with a dry cloth. Take care not to get the gasket
wet or allow moisture into the door.
• Inner glass: The inner glass is cleaned automatically during the self-cleaning
cycle.
• Wear the glove during cleaning.
Outer side
• Outer surface: Follow the cleaning instructions for the stainless steel surface in
the previous section.
• Outer glass: Clean the outer glass using a glass cleanser or soapy water. Rinse
and dry thoroughly. Take care not to get the gasket wet or allow moisture into
the door.
*
Surface burners
Burner controls
Make sure all surface burner knobs are in the OFF position.
CAUTION
Do not let moisture enter the door or
contact the door gasket (*). Moisture may
reduce the gasket's performance.
1. Pull out the knobs from the control
valve stems as shown.
2. Clean the knobs in warm, soapy water.
Then, rinse and dry them thoroughly.
3. Clean the stainless steel surfaces using
stainless steel cleaner.
4. Reinsert the knobs into the control
valve stems.
English 45