Continuous Forms With Labels - Epson DLQ-3500 Quick Manual

To tear off and eject labels
Always tear off and eject labels as described
below.
c
Caution:
Never feed labels backward using the
Load/Eject button, Tear Off/Special
Paper button, or knob on the right side
of the printer. Labels can easily peel off
their backing and jam the printer.
1. At the back of your printer, tear off the
last label form that has entered the
printer, but do not press the Tear
Off/Special Paper button. See the
illustration below.
2. Press the LF/FF button to eject the last
label form forward.
c
Caution:
Do not leave labels loaded in the printer
between print jobs; they tend to curl and
may come off their backing sheet and jam
the printer when you resume printing.
EPSON DLQ-3500 Quick Guide

Continuous forms with labels

The continuous forms with labels is a type of
continuous paper with one label on each
page. This is different from label paper,
which consists entirely of labels. When
printing on this type of paper, the printer
must adjust the height of the print head for
the extra thickness of the labels.
Follow these steps to load continuous forms
with labels:
c
Caution:
Use continuous forms with labels only
under normal operating conditions.
1. Make sure of the following:
❏ Your software settings keep the
printing entirely within the
printable area. See "Printable area"
in the Reference Guide for more
information.
❏ Tractor is selected as the paper
source on the control panel.
2. Turn on Overlapping Forms and Skip
over perforation settings in the
default-setting mode.
Note:
When Overlapping Forms is turned on in
the default-setting mode, the printer
automatically activates the auto paper
thickness function even though the
paper-thickness lever may be set to another
position.
Special Papers (3/6)